Hi all,
We’re producing a data logger with WiFi. 
As part of our production finalization process, we need to fasten an SMA pigtail connector to our PCB.
Currently we do this on the PCB before we slide the PCB into our enclosure – but that creates a number of inefficiencies.
It would be far more ideal if we could fasten the pigtail connector after the PCB is in the enclosure – but to do so, we need an adequate tool.
I’ve attached a picture. The pigtail connector is ~1 CM inside the enclosure and there’s ~1.5/1.0 cm above/below the PCB inside the enclosure.
Any suggestions for tools would be much appreciated!

Best,