I have a board with a 3-mm × 3-mm, 16-Pin QFN package – so I ordered the PCB with a stencil (multi-cb).
Their standard stencil is 100um (or 120um?) thick.
Seems I get quite a lot of paste on the board (see picture) with this setup. I taped the board to the table and then taped the stencil on top.
Any good techniques for getting less paste onto the board?
-thinner tape? thinner stencil?
-minimize buckling and bowing of stencil – how?
-paste-application technique? I ran a sharp knife-edge with paste tilted at ~45-deg across the stensil..
-paste type? I think this is chip-quick (don’t remember part-nr…)
I hope I got the QFN soldered OK – after hot-air gun I applied a bit of flux and ran a soldering iron across the pins to remove solder-bridges on two of the four sides…

thanks for suggetions!